Connecting a 3-Way in MINI R4 in a different way - Free discussion - eWeLink Forum

I am intending to use the Sonoff Mini R4 connecting a 3-way connector whose central pin I will connect to the S2 input. Input S1 will be free, as shown in the diagram. I have no condition to pass other cables.The load is 127V. However, the line (let’s call it L1) that will go into connector S2 is different from the line that will go into Lin (let’s call it L2). Both lines are 127V, but they have different phases. Am I clear? Any problems with this connection? I mean, does it matter if Lin and

Float Switch with Sonoff - Free discussion - eWeLink Forum

Sonoff ZBMINI Extreme and T2 switch - eWeLink Forum

Using sonoff basic R4 with 2 way switch - Configuration - Home Assistant Community

Electronics Tutorials, Forums, Tools, IoT, and More

Adding geyser control to smart home - wiring question - Home Automation - Power Forum - Renewable Energy Discussion

Help connect a 3 way switch with 4 wires. There is an additional wire on top of the ground screw. : r/askanelectrician

Sonoff MiniR4 Extreme - Hardware - Home Assistant Community

Make HomeLink work with any garage door (also: automate just about anything using HomeLink) : r/teslamotors

Connecting sonoff to the deco network (x20) - Home Network Community

Sonoff ZBMINI Extreme and T2 switch - eWeLink Forum

Sonoff MiniR4 Extreme - Hardware - Home Assistant Community

Confirming 4 way wiring, no neutral, source at fixture - Wiring Discussion - Inovelli Community