Pin Mapping for Orange Pi 4 LTS for ADXL345 - General Discussion - Klipper

I am using an Orange Pi 4 LTS to run Klipper, and I am trying to connect my ADXL345 which was previously connected to a Rpi3B. It has a 23 pin header instead of 40- is this possible? These are the two pinout diagrams, but I cannot find an Rpi mapping, nor make sense of the names enough to convert. Any help is appreciated!

Orange Pi 4 LTS Review: A Low Price Raspberry Pi 4 Alternative

Unable to use adxl345 on RPi4b · Issue #4314 · Klipper3d/klipper

PDF) Development of a Low-Cost Vibration Measurement System for

PDF) Development of a Low-Cost Vibration Measurement System for

Orange Pi 3 LTS ADXL345 : r/klippers

Orange Pi 3 LTS ADXL345 : r/klippers

Is it possible to connect adxl345 to orangepi 3 lts? : r/OrangePI

ADXL345 Raspberry pi4 multi SPI - General Discussion - Klipper

Is it Adxl345 possible without raspberry pi? : r/klippers

Setting up ADXL345 on orange pi lite 2 - General Discussion - Klipper

ADXL345 Raspberry pi4 multi SPI - General Discussion - Klipper